Fairbanks Aegis Heavy Capacity PLF-6200-HQ Series - Manual (Page 9)

Accessories: Bolt-down plates, Ramps, Bumper-Guards, and Pit-frames are installed as
follows:
$ %ROW'RZQ3ODWHV
Bolt down plates are used to keep the scale from sliding or moving when loads are
applied. The plates are bolted via anchors at each of the scales feet.
To install:
1. Place the platform in position
2. Place the bolt-down plate under the foot, plate edge extending out from
under the scale.
3. Drill the two holes using a hammer drill. Insert anchors with the nut and
washer already ON. Tap the anchor into the hole then tighten the nuts
securely. Repeat this process for each plate used.
% 5DPSV
Each ramp accessory comes with two integral bolt-down plates and four anchors.
Installation:
1. Place the ramp in position, then lift and set the platform feet into the bolt-
down plate holes.
2. Drill the two holes using a hammer drill. Insert anchors with the nut and
washer already ON. Tap the anchor into the hole then tighten the nuts
securely.
• If two ramps are installed, NO other bolt-down plates are needed
• If one ramp is installed then a set of two bolt-down plates are needed
• Only two ramps total may be installed on opposite sides of a scale platform.
50637 / SJ4799 9 08/02 Issue 2
6HFWLRQ $FFHVVRULHV
Note:
If ramps are NOT installed and bolt-down plates are required, then a set of four bolt-down
plates are required.