Fairbanks Ultegra Health Scale - Manual (Page 6)

Section 2: Operation
A. Unpacking and Setup
1. Remove the scale from the packing box.
2. Place on a flat surface where it will be used.
3. Using the level bubble, adjust one or two feet minimally to level platform.
(Do NOT adjust all 4 feet.)
4. Optimal leveling is indicated when the bubble level appears as shown below.
B. Connections
1. Plug display interface cable into the scale base where marked.
Refer to illustration below.
2. Plug AC power adpater into the the scale base where marked.
Refer to illustration below.
3. Plug RS 232 interface cable into the scale base where marked, if required.
Refer to illustration below.
C. Operating Controls
The keys for operating the scale are located on the display.
1.
Pressing the ZERO key resets the display to indicate zero (0), the center-of-zero
(>0<) indication will be displayed.
• The zero range is set at 2 % of capacity when set for Canadian use.
• The zero range is set at 100% of capacity when set for USA use.
2. The ZERO key function will be inhibited if the instrument detects any of the
following conditions:
a.
Motion on the platform
b. An underload condition
c. An overload condition
d. Outside of programmed zero range
3. Pressing the UNITS key toggles the weighing units and the display 'indicators' from
"lb" to "kg." Set to the units you will use by noting the arrow 'indicator' in the display.
08/08 6 50735 Rev. 6
Display Output
50736-1
RS232 Output
AC Adapter