Fairbanks 1155 SERIES Portable Utility SCALE WITH THE FB2255 - Manual (Page 12)

02/13 12 51315 Rev. 1
Section 2: Assembly
2.1. NECESSARY TOOLS
 Small Slotted Screwdriver
 Phillips Screwdriver
 10" Adjustable Wrench
 Common Pliers
2.2 WHEEL & PILLAR ASSEMBLY
1. Set the Scale Base Assembly (#4 ) sideways on the floor.
2. Insert a cotter pin (#17 ) through the small hole in one end of the first axle
( #19 ).
3. Place a flat washer ( #18 ) and a wheel ( #16 ) onto the open end of the axle.
4. Insert the axle's other end through both holes in the base.
5. Place the second wheel ( #16 ) onto the axle.
6. Place a flat washer over the axle, and then insert a cotter pin through the axle’s
small hole.
7. Repeat steps 2-4 for the second axle.
8. With the scale in its upside-down position, center the axles in the base.
9. Insert the locking screws ( #15 )
into the tapped holes in the bottom
of the base, tightening the axle into
place with the screws.
─ Directly under the axle holes.
10. Secure the lock nuts ( #14 ).