Allied Telesis AT-WA1104G-10 - Manual (Page 51)

Features in 291-05 51
Version 291-10
C613-10488-00 REV G
CR00015558 ASYN 3 Under some circumstances, when a PC terminal emulator was opened to
communicate with a router or switch after the router or switch had fully booted
up, the login prompt did not immediately display. To display the login prompt, it
was necessary to remove and re-insert the cable. This issue applied to all models’
ASYN ports except ports on the AR024 PIC.
This issue has been resolved.
Y Y Y Y Y Y Y Y Y Y
CR00015690 DHCP6 3 In the command create dhcp6 range, the ip parameter correctly has the syntax
prefix1[-prefix2]. However, the second prefix was previously not optional.
This issue has been resolved, so that the second prefix (of the form ipv6address/
prefixlength) is no longer required. If you do not enter a second prefix, it is now
calculated from the first prefix. The second prefix has the same prefix length at
the first and has all 1s in the non-significant part of the address. For example, the
second prefix for 3ffe:1:2:3::/64 would be 3ffe:1:2:3:ffff:ffff:ffff:ffff/64.
Y Y Y Y Y - - Y Y Y
CR00015881 SNMP, Switch 3 The SNMP objects dot3StatsSQETestErrors and dot3StatsCarrierSenseErrors are
not supported on AR750S, AR410, and AR450S routers. Previously SNMP GET
got a random value for these objects.
This issue has been resolved. SNMP GET now gets 0 for these objects.
Y - Y - - - - - - -
CR00015969 WAN load
balancer
3 After the command reset wanlb resource=all was entered, WAN load balancer
resources would show their state as “UP” even if the underlying IP interface was
down.
This issue has been resolved.
Y Y Y - - - - - - -
CR00016001 DHCPv6 3 When a DHCPv6 client was soliciting for servers, the selection of the best server
did not proceed in the way specified by the RFC.
This issue has been resolved.
Y Y Y Y Y - - Y Y Y
CR00016177 Switch, MIB 3 The default value of the MIB object ifJackType for the GBIC slot on AT-8800 series
switches was incorrect if no GBIC card was plugged in.
This issue has been resolved. The default value is now “other(1)”.
- - - - Y - - - - -
CR Module Level Description AR4
00
AR7
x5
AR7
x0S
Rap
ier i
AT
-8800
A
T-8
600
A
T-8
700
XL
x900
-48
A
T-
99
00
A
T-9
800