Fairbanks FB6002 INSTRUMENTATION - Manual (Page 80)

01/13 80 51293 Rev. 2
Attach Remote Switch wires to
Terminal J17 of the Base Board.
Appendix II: Remote Switch Wiring
NOTE: The Remote Switches and the 20mA share a ground wire.
– This means that remote switches, if used simultaneously with a remote display,
must NOT be grounded. Otherwise they risk creating a ground loop thorough
the instrument’s main circuit board.
– Connect Switch Legs to non-grounded-bonded dry contact only. If the display is
fully isolated (non-bonded), this is not an issue
J 17 CONNECTION FUNCTION
1 and 2 Zero
3 and 4 Print
5 and 6 Tare
7 and 8 Gross/Net