Fairbanks 4000 SERIES Pallet Weigh - Manual (Page 12)

05/12 12 51285 Rev. 1
Section 3: Installation
3.1. SYSTEM SET UP
Installation of pump handle
Make sure the lever is pushed down to the
“pump” position. Thread the chain through the hole in the
triangle and through the hole in the axle.
Place the handle bar onto the triangle and
insert the bolts.
Tighten the bolts firmly.
Push the silver part “A” on the outside of the
pump downwards.
At the same time; insert the chain into
the open side of the slot “B” on the
inside of the pump.