Fairbanks Zebra GC420d - Manual (Page 97)

85
ZPL Configuration Status to Command Cross-reference
5/23/2012 GC420d™ User Guide P1052685-001
The configuration settings listed here resume after the TAKE LABEL sensor value. These
listings contain printer features seldom changed from default or provide status information
(e.g. Firmware Version).
Table 3 • ZPL Commands and Configuration Receipt Callout Cross-Reference
The printer has the ability to set a command or a group of commands once for all receipts (or
labels) that follow. Those settings will remain in effect until they are changed by subsequent
commands, the printer is reset, or you restore factory defaults.
Command Listing Name Description
^MP
MODES ENABLED Default: CWF (See ^MP Command)
(CWFM for wireless printers with display)
MODES DISABLED Default: (nothing set)
^JM
RESOLUTION Default: 832 8/mm FULL (203 dpi)
1280 8/mm FULL (300 dpi)
—
FIRMWARE Lists ZPL Firmware Version
—
XML SCHEMA 1.3
—
HARDWARE ID Lists Firmware Boot-block Version
—
CONFIGURATION CUSTOMIZED (after first use)
—
RAM 2104k........ R:
—
OPTION MEMORY 56532k.......B: (only displays this if installed)
—
ONBOARD FLASH 5632k.........E:
^MU
FORMAT CONVERT NONE
^JI / ~JI
ZBI DISABLED (Requires key to enable)
—
ZBI VERSION 2.1
^JH
^MA
~RO
LAST CLEANED X,XXX IN
HEAD USAGE X,XXX IN
TOTAL USAGE X,XXX IN
RESET CNTR1 X,XXX IN
RESET CNTR1 X,XXX IN
—
SERIAL NUMBER XXXXXXXXXXX
^JH
EARLY WARNING MAINT. OFF