Fairbanks Zebra GC420d - Manual (Page 99)

87
Printer Memory Management and Related Status Reports
5/23/2012 GC420d™ User Guide P1052685-001
Table 4 • Object Management and Status Report Commands
Command Name Description
^WD
Print Directory Label Prints a list of objects and resident bar codes and
fonts in all addressable memory locations
~WC
Print Configuration
Label Prints a configuration Status Receipt (Label)
Same as Feed Button mode one flash routine
^ID
Object Delete Deletes objects from printer memory
^TO
Transfer Object Used to copy an object or group of objects from
one memory area to another.
^CM
Change Memory Letter
Designation Reassigns a letter designation to a printer
memory area.
^JB
Initialize Flash memory Similar to formatting a disk - erases all objects
from the specified memory locations B: or E: .
~JB
Reset Optional Memory Similar to formatting a disk - erases all objects
from the B: memory (factory option).
~DY
Download Objects Downloads and installs wide variety of printer
usable programming objects: fonts (OpenType
and TrueType), graphics, and other object data
types.
Recommendation: Use ZebraNet™ Bridge for
downloading graphics and fonts in the printer.
~DG
Download Graphic
Downloads an ASCII Hex representation of a
graphic image. This is used by ZebraDesigner™
(label creation application) for graphics.
^FL
Font Linking Appends secondary TrueType font or fonts to the
primary TrueType font to add glyphs
(characters).
^LF
List Font Links Prints a list of the linked fonts
^CW
Font Identifier Assigns a single alphanumeric character as an
alias to a font stored in memory.
Important • Some factory installed ZPL fonts in your printer cannot be copied, cloned or
restored to your printer by reloading or updating firmware. If these license restricted ZPL fonts
are removed by an explicit ZPL object delete command, they must be repurchased and
reinstalled via a font activation and installation utility. EPL fonts do not have this restriction.