Farm Star SRTC-406A - Manual (Page 33)

11 32
SAFETY INSTRUCTIONS
(continued)
Always stop the tractor, set brake, shut off the tractor engine, remove the ignition key, lower implement to the
ground and allow cutter blades to come to a complete stop before dismounting tractor. Never leave equipment
unattended with the tractor running. Park in level area.
Always sit in power unit seat when operating controls or starting engine. Securely fasten seat belt, place trans-
mission in neutral, engage brake, and ensure all other controls are disengaged before starting power unit
engine.
Never place hands or feet under cutter with tractor engine running or before you are sure all motion has
stopped. Stay clear of all moving parts. Do not reach or place yourself under equipment until it is blocked
securely.
Do not allow riders on the rotary cutter or tractor at any time. There is no safe place for any riders.
Disengage power takeoff (PTO) and place transmission into neutral before attempting to start engine.
Do not operate unless all personnel, livestock, and pets are several hundred feet away to prevent injury by
thrown objects. Never direct discharge toward anyone.
Install and secure all guards and shields before starting or operating.
Keep hands, feet, hair, and clothing away from moving parts.
This rotary cutter is designed for use only on tractors with 540 RPM power takeoff.
Never operate tractor and cutter under trees with low hanging limbs. Operators can be knocked off the tractor
and then run over by the rotating blades.
The rotating parts of this machine have been designed and tested for rugged use. However, they could fail
upon impact with heavy, solid objects such as steel guard rails, posts, and concrete abutments. Such impact
could cause the broken objects to be thrown outward at very high velocities. To reduce the possibility of
property damage, serious injury, or even death, never allow the cutting blades to contact such obstacles.
Frequently check cutter blades. They should be sharp, free of nicks and cracks and securely fastened.
Many varied objects, such as wire, cable, rope, or chains, can become entangled in the operating parts of the
cutter head. These items could then swing outside the housing at greater velocities than the blades. Such a
situation is extremely hazardous. Inspect the cutting area for such objects before mowing. Removing any like
object from the site. Never allow the cutting blades to contact such items.
Pick up all rocks and other debris before mowing. Enter new areas carefully. Cut material higher at first,
allowing cutter to clear hidden objects. Never assume an area is clear. Always Check!
OPERATIONAL SAFETY (continued)
ASSEMBLY / REMOVAL OF
SHIPPING STANDS
1. Remove loose parts attached to the cutter on the
underside of the deck and remove additional hardware
from inside of the OM tube.
2. Wrap lifting strap or chains around cutter rear support
frame and attach to a hoist.
3. Lower machine onto 4 inch wood blocks.
4. Remove all shipping bands, wires and loose parts
from around the cutter.
5. Remove shipping stands from cutter by removing hitch
pins (A) and 1/2” bolts (B). Discard shipping stands,
flat washers and bolts.
6. Install hitch pins and tighten to specified torque.
INSTALL TAILWHEEL SUPPORT
1. If necessary, remove tailwheel support from shipping
position.
2. Place tailwheel support between brackets on deck.
3. Install 1/2” x 4” bolt, washers and lock nut.
4. Install 1/2” x 4” bolt, and lock nut into one of seven
holes that aligns with hole in wheel support. (See
Adjusting Cutting Height and Angle in Operation the
Cutter section.)
5. Tighten hardware.
WARNING!
To help prevent bodily injury from accidental lower-
ing of the cutter, attach a lifting strap or chains to
cutter rear support frame and a hoist.
REMOVE SHIPPING DUNNAGE
AND PARTS
——————————————————