Gentec-EO Beamage-M2 - Manual (Page 7)

Beamage-M 2 User Manual Revision 2.0 7
Figure 3-33 M 2 Beams configurations : Multiple automatic exposure time detection, multiple manual active
areas and selection to see the fifteenth beam exposure time into the displays .................................................... 36
Figure 3-34 M
2 Beams configurations : Multiple automatic exposure time detection, multiple manual active
areas and removing of the sixth and sixteenth beams into the displays ................................................................ 36
Figure 3-35 M
2 without beams 15 and 16 ............................................................................................................... 36
Figure 3-36 M 2 Selective Beams configuration ....................................................................................................... 37
Figure 3-37 M 2 Print Report Example ...................................................................................................................... 38
Figure 3-38 Open/Save File Controls ....................................................................................................................... 39
Figure 3-39 M
2 Measures Tab ................................................................................................................................. 39
Figure 3-40 Save/Load Calibration Settings............................................................................................................. 40
Figure 4-1 X-ADJ Screw Alignment to Rotate the Beams Around the First Spot ..................................................... 41
Figure 4-2 Full rotation around the first spot .......................................................................................................... 42
Figure 4-3 Adjust Setup to Place the First Spot on the Left-Hand Side of the Screen ............................................ 42
Figure 4-4 Y-ADJ Screw Alignment to Change the Distance Between the Beams ................................................... 42
Figure 4-5 Minimum Beam Waist Too Far on the Left ............................................................................................ 43
Figure 4-6 Overlap Problem .................................................................................................................................... 43
Figure 4-7 Curve in the Alignment of the Beams .................................................................................................... 43
Figure 4-8 Top View ................................................................................................................................................. 44
Figure 4-9 Side View ................................................................................................................................................ 44
Figure 4-10 Reflection Problem ............................................................................................................................... 44
Figure 4-11 Overlap Problem solved with Y-ADJ ..................................................................................................... 45
Figure 4-12 The Minimum Beam Waist is Too Far to the Left ................................................................................. 45
Figure 4-13 Beams at the extremities have smaller diameters ............................................................................... 46
Figure 4-14 Moving Stage Calibration Measures .................................................................................................... 47
Figure 4-15 Moving Stage Calibration Optical Setup............................................................................................... 47