Kasco Marine LE375 - Manual (Page 5)

5
STEP THREE:
Adjust the angle of the light as desired and tighten the
two brass screws on the sides of the fi xture until snug.
Do not over tighten. It is best to have all two or three
fi xtures at the same angle.
STEP FOUR:
Repeat steps 1 through 3 for the remaining fi xture.
The completely assemble light fi xture is pictured in
Figure 9. Note the orientation of the lights.
Figure 9
2 light install
Figure 10
3 light install
STEP FIVE:
Using the nylon cable tie provided, tie the light kit
power cord to the fl oat or rope opposite the fountain
power cord. This will keep the cord from being
damaged by the fountain and balance the unit properly.
STEP SIX:
Each light fi xture and cord entrance must be
submerged at least 25mm in order for lights to operate
properly.
STEP SEVEN:
Upon installation of the assembled unit, connect your
lighting package to your control box. It must be
connected to an RCD protected circuit 220Vac 50/60
hz.
LE375 Light Kit Assembly
Instructions
Instructions for mounting lights on
Models 4400EJF, 8400EJF, and 3.1EJF Aerating
Fountains
STEP ONE:
Cut Nylon Zip Ties that hold the fi xture cords in a coil.
Insert the 1/4” x 3/4” bolt into the light bracket so
the fl ats of the hex head bolt are between the support
ribs of the bracket as shown in Figure 10. Align the
light bracket to the lower fl oat bracket by placing the
TOOLS & SUPPLIES NEEDED
A. 7/16” Wrench •
B. Flat Head Screw Driver •
C. Diagonal Pliers or Cutter for Nylon Zip Ties •
LE275 Light Kit Assembly
Instructions
Instructions for mounting lights on
Model 2400EVFX, 2400EJF, 3400EVFX, and
4400EVFX Aerating Fountains.
STEP ONE:
Cut Nylon Zip Ties that hold the fi xture cords in a coil.
Insert the 1/4” x 1” bolt into the light bracket so the
fl ats of the hex head bolt are between the support ribs
of the bracket as shown in Figure 6. Align the light
bracket to the fl oat tab by placing the bolt through the
light mounting hole in the underside of the fl oat tab as
shown in Figure 7.
Fig.6
Fig.7
Light bracket
mounting hole.
STEP TWO:
Install the 1/4” Flat Washer, 1/4” Lock Washer and
1/4” Nut against the underside of the fl oat tab as
shown in Figure 8. Tighten the nut until snug using
the 7/16” Wrench.
Fig.8
nut
fl oat fl at washer
lock washer