LOCKSTATE RL2000/LS-1250 - Manual

Front Handle & Key Installation
1. Ensure that the key override slot
is in the horrizontal position.
2. Slide the key cylinder into the
back of the handle.
3. Insert the key into the key cylin-
der from the front of the handle
and turn 90 clockwise.
5. Press in both catch pins and snap
handle over pins.
4. Slide the handle onto the brass
drive shaft until it hits the catch
pins.
6. Turn key back to the left and
remove the key from the key
cylinder.
Step 3
Screw in and tighten both fastener
extensions (D). Attach and tighten
optional upper fastener post (E) if
needed. Upper post is recommended
but not required.
Step 4
Place the front of the lock onto the door
with the rubber gasket (F) between the
door and the lock housing. Feed the
power cable (G) through the door hole.
Step 5
Attach the battery plate on the inside
door with the rubber gasket between the
door and battery plate. Feed the power
plug through the small rectangular hole
on the plate. Secure the battery plate to
front lock fastener posts with 2 screws.
Step 6
Install 4 AA batteries and plug in the
power cable (G). Secure the back lock
housing onto the battery plate with the
upper and lower screws. Press both
catch pins in and snap the rear handle
onto drive shaft.
G
Major Lock Parts List
Installation Instructions
Step 1
Insert the latch into the latch
hole. Secure the latch with two
screws.
Step 2
Insert the square spindle (A) into the center hub
(B). Then secure the spindle by inserting the
position pin (C) through the hole in the hub &
spindle. Bend the ends of the pin around the hub
to secure.
Installation & User
Manual
For use with ResortLock® RL2000 and LockState® LS-1250
®