LOCKSTATE LS-17EN - Manual

CAUTION: Do not keep the keys in the safe.
1. OPENING THE SAFE FOR THE FIRST TIME
To open the safe for the first time, remove the small central sticker on the front
panel that has a picture of a key on it (see “Z” in diagram 2 below). This will
reveal a keyhole underneath. Insert the key into the keyhole and turn it counter-
clockwise, at the same time turn the doorknob clockwise and pull the safe door
open.
2. INSTALLING THE BATTERIES
The safe requires 4 size “AA”(1.5V) batteries. The battery compartment (see “Z”
in diagram 1) is located on the back of the door. Remove the battery cover and
install the batteries into the compartment, ensuring the batteries are fitted with
the correct corresponding polarity. Once the batteries are installed, close the
battery compartment.
3. PROGRAMMING THE CODE
A. Press the red button on the back of the door near the hinges (see “X” in
diagram 1), release it and you will hear two beeps.
B. Now enter a code (3 to 8 digits) that you wish to use as a combination, and
confirm by pressing the “B” button on the keypad within 15 seconds. If you wait
too long before pressing the “B” button you will need to start over.
C. Write down your new combination immediately and test your new
combination to ensure that it has been programmed.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL
REQUIREMENTS, WARNINGS AND CAUTIONS. USE THIS PRODUCT ONLY FOR ITS INTENDED
PURPOSE. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY. PLEASE KEEP
THESE INSTRUCTIONS IN A SAFE PLACE FOR FUTURE REFERENCE.
!
www.LockState.com
OPERATING INSTRUCTION for LockState Safe LS-17EN
Thank you for purchasing the LockState LS-17EN safe. This safe will install easily on
a floor, in a closet or on a wall. This easy quick-start guide will help you through
the installation and programming process.