LOCKSTATE LS-17EN - Manual (Page 2)

4. INSTALLING YOUR SAFE
A. To install your safe on a floor or a wall, hold the safe against the floor or wall
in the exact position it will be installed. With a pencil, trace the pre-drilled holes
(on the safe’s bottom for floor and the safe’s back for a wall) making a mark.
Remove the safe and drill a hole in each of the two traced marks. Make sure the
depth and width of the hole is suitable for the anchors that will be placed into the
holes. Push an anchor into each hole. Again, hold the safe against the floor or
wall in the exact position it will be installed and screw one bolt in each of the
anchors from the inside of the safe (see diagram 1).
5. USING YOUR SAFE
To open the safe, enter your combination code and confirm by pressing the “A”
button. You will hear a beep and the green light will light up. Within 5 seconds,
open the door using the knob.
If an incorrect combination is used 3 times consecutively, you must wait for 20
seconds before reattempting to open the safe. If again, after the 20 second wait,
an incorrect combination is entered 3 times consecutively, you must wait
approximately 5 minutes before reattempting access.
6. BATTERY REPLACEMENT WARNING
If the batteries are low, the red light (on the left) will warn you immediately upon
an access attempt. To test the batteries, simply input your combination to open
the door. If the batteries are low, the red light will light up. If there is no red light
when accessing the safe then the batteries are in good condition.
7. REPLACING THE BATTERIES
The safe requires 4 size “AA” (1.5V) batteries. Open the safe, then open the
battery cover plate (see “Y” in diagram 1) on the back of the door and replace the
old batteries. **Upon replacing the batteries you must reprogram your
combination using Step 3 above. Use of alkaline batteries is recommended.
8. OVERRIDE INSTRUCTION TO OPEN THE SAFE
Your safe comes with a manual override system. If you forget or misplace your
combination, remove the small central sticker on the front panel with the key
picture on it (see “Z” in diagram 2). Insert the key into the keyhole and turn
it counter-clockwise, then turn the knob clockwise (towards the right). This will
manually open your safe.***DO NOT LEAVE THE KEYS IN THE SAFE***