Audiovox 50-0301x-002 SERIES - Manual (Page 5)

5
10. Install foam tape (item 5 pg 2) along each side of
mounting bracket where lines were previously
marked. See Figure 7.
11. Remove adhesive backing from Velcro tape along
bottom of VCP bracket. See Figure 7.
12. Install VCP housing (item 4 pg 2) and secure to
mounting bracket using (2) two # 8 X 9/16" screws,
removed in step 4. (item 1 pg 2). See Fig. 8. Make
sure Velcro tape adheres to bottom of VCP housing.
13. Trim floor mat, if applicable, to fit around VCP
housing. See Figure 9.
14. Raise seat into locked upright position.
15. Replace storage cover, if applicable, in original
location.
FIGURE 8
FIGURE 9
FIGURE 7