Reversomatic RI 150 PS, RI 200 PS, RI 250 PS - Manual (Page 3)

790 Rowntree Dairy Road, Woodbridge ON, Canada L4L 5V3
Tel: 905-851-6701 Fax: 905-851-8376 [email protected]
w w w . r e v e r s o m a t i c . c o m
FANS WITH PRESSURE SENSORS
INSTALLATION INSTRUCTIONS
NO
NC
COM
Adjusting
Screw
1/8” NPT
Connection
Without Fitting
Compression Fittings Shown
Other Fittings Available
Timer
Adjusting Screw
Terminal Block
Capacitor
PRESSURE SENSOR AND
ELECTRICAL BOX DETAIL
IMPORTANT :
WHEN MOUNTING PRESSURE SENSOR. ALWAYS KEEP THE
ADJUSTING SCREW IN THE TOP POSITION (SEE FIG. 1) WHEN SITE
CONDITIONS REQUIRE THE FAN TO BE MOUNTED IN THE OPPOSITE
POSITION (SEE FIG.2 ROTATED 180 DEG.), THE PRESSURE SENSOR
WILL NEED TO BE ROTATED (REMOVE SCREWS FROM BRACKET,
ROTATE PRESSURE SENSOR, THEN RE-INSTALL).
NOTE: Models may be mounted in a Horizontal or Vertical position.
All switches are tested at the factory in a vertical position. Locations
of fittings and types of fittings may vary from unit to unit.
MOUNTING diaphragm in vertical position is the preferred method.
MOUNTING in horizontal position, micro switch must be on the top.
When mounted in this position, the minimum sensitivity may be higher
than that specified.
Rubber Isolator
Suspension
Bracket
(Optional)
Mounting Clamps
(Optional)
Pressure
Sensor Barb
(Never Pointing
Downward)
Tubing
Pressure
Sensor Barb
(Never Pointing
Downward)
Tubing
FIG. 1 FIG. 2
ROTATED 180
RANGE ADJUSTMENT
All settings are made with the diaphragm in a vertical position. The switch is shipped with the adjustment at minimum (0.05” W.C.)
To adjust, turn adjusting screw with screwdriver. To increase pressure setting, turn adjustment screw down in a clockwise direction.
To decrease pressure setting, turn adjusting screw up, in a counterclockwise direction.
If adjusting screw is removed, apply a non-hardening pipe compound to the threads before replacing. Check for leaks with a soap
bubble test using maximum 20” W.C.)
joel tantay 5.19.09