Reversomatic TLD 200 1 inlet User Manual
Page 3
FAN
HINGE
MOTOR
MOUNTING PLATE
WING NUT
FAN BLADES
790 Rowntree Dairy Road, Woodbridge ON, Canada L4L 5V3
Tel: 905-851-6701 Fax: 905-851-8376 [email protected]
w w w . r e v e r s o m a t i c . c o m
TLD - 200 & TLD - 300
CLEANING INSTRUCTIONS
INSTRUCTIONS:
1. Before cleaning the unit, switch power off at service panel and lock it. If service panel is unlocked
others could turn the power on unexpectedly and cause fatal electric shock to the cleaner.
2. Make sure there is no power to the motor.
3. Clean fan blades of lint accumulation with a cloth or small smooth brush as required (at least twice
annually) by removing two wing nuts from the motor mounting plate then motor will swing open.
4. Tighten the wing nuts after cleaning.
5. Turn the power “ON” and check if the fan is working properly.
6. It is recommended that a Lint Trap be installed.