Rivers Edge RE619 LumberJack Extrme - Manual (Page 5)

Check for parts online at www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5 5
Operator's Manual
Rivers Edge One-Man Ladder Stands
uSING YOuR full BODY hARNESS
(fAll ARREST SYSTEM)
PuTTING ON YOuR full BODY hARNESS
1. With the Full Body Harness (FAS) lying on the ground, familiarize yourself
with all of its design and features. SEE fIGuRE 1.
2. Loosen both leg straps to the maximum position and unthread the waist
belt completely. Doing both of these actions will allow you to put the Full
Body Harness (FAS) on easier.
3. Now holding the harness, locate the (2) shoulder straps labeled “LEFT
SHOULDER” and “RIGHT SHOULDER”, and spread them apart to make sure
there are no twists or tangles in the harness. SEE fIGuRE 2.
4. Position yourself in front of the harness and proceed to step through each
leg loop as if you were putting on a pair of pants. SEE fIGuRE 3.
5. Pull harness up your body to chest height where you will slide your left arm
through the “LEFT SHOULDER” strap and your right arm through the “RIGHT
SHOULDER” strap as if you were putting on a jacket. SEE fIGuRE 4.
notE: be sure there are no twists in leg or shoulder straps. the “lEFt
ShouldER” and “RiGht ShouldER” printing should be away from your
body so you can read the words while wearing the Full body harness (FaS).
if not, the harness is on inside out and must be switched.
Figure 2
right shoulder
left shoulder
Figure 3
leg loops
Figure 4
Figure 1
tree belt
tether
right shoulder strap
leg
straps
left shoulder
strap
adjustment slides
waist strap