Ronan X11CA Hardware Manual - Manual (Page 22)

Rev 1.0 Series X11CA Hardware Manual
2. X11CA Hardware Setup
Hardware Control-© 2002 Ronan Engineering 18
Place the second clamp into the center of the groove behind the extruded
trim of the cabinet and then slide it into about one third from the top right
corner of the cabinet. Tighten each jam screw to secure the cabinet to the
panel cutout. Tighten the lock nuts on each screw.
Figure 2-16 Detail A
4. Repeat step three for installing the bottom two clamps.
5. Refer to the wiring diagrams on the CD for wiring instructions.