Salamander Designs SN/PM/A - Manual (Page 2)

BEFORE YOU BEGIN
• Carefully inspect the mount for shipping damage or missing parts. If any damage is apparent or you are missing parts contact
Salamander Designs at 800-535-5659.
• Read ALL assembly instructions before assembly. If you have any questions, please contact your installation contractor
or Salamander Designs.
• This TV mount is intended for use with Flat-Panel TV 50” or smaller.
• Total weight capacity of TV
WITH optional speaker mount kits: Synergy Twin Cabinet Mount (SO/PM): 150 lbs.
• Use with products heavier than the maximum weight or larger than the size indicated may result in instability causing possible injury.
• Mounts must be attached as specified in assembly instructions. Improper installation can result in serious personal injury.
LIMITED WARRANTY - For five full years Salamander Designs Ltd. will repair or replace, at our option, any product defective
in materials or craftsmanship. Salamander Designs Ltd. will not be responsible for any damage to or destruction of other equipment
consequential to our equipment failure. Defective product must be given Return Authorization and is to be returned to the factory
prepaid, in the original carton and packing material. Any damage incurred in a shipment not in original packaging shall be the
responsibility of the owner. Warranty repairs will be returned prepaid, via UPS within the continental U.S.A. only.
NOTE:
If installing mount to an assembled twin unit, remove
the rear center connector bolt. Replace with base plate (D).
1
.
Install Base Plate
A. Loosely assemble 2 flat nuts (R) with 2 button
head screws (Q) through the base plate (D).
B. Secure the base plate (D) to rear center post with the 2” button
head screw (G) and washer (H).
Tighten firmly with hex key (U).
Salamander Designs Ltd. www.salamanderdesigns.com 800-535-5659
© 2012 Salamander Designs Ltd. Doc No. 500-885 / v10.12 / 2 of 5
Q
D
R
BA
C
K
ED
G
E
U
G
H
D