Securitron SWB-26D - Manual (Page 2)

PN# 500-22200
Page 2 Rev. C, 03/11
Disassemble the Strike from the Idle Bracket as shown in Figure 3. Mount the Idle Bracket as noted in
the SAM, SAM2 Shear Aligning Magnalock manual Section 2.3.5 using the #8 x ¾” screws provided.
Reassemble the Strike Assembly to the Idle Bracket as shown in Figure 4.
Figure 3 Figure 4
5.2 Reinforcement Bracket Installation
Place the reinforcement bracket on top of door and align over the strike assembly area. Mark the six
(6) holes on both sides of the door. Remove the bracket and drill the holes using the 9/64” drill 5/8” –
3/4” deep. Place the reinforcement bracket back on top of the door and install the six (6) screws
provided as shown in Figure 5.
Figure 5