Securitron TJ-68 - Manual (Page 5)

PN# 500-19900
Page 5 Rev. F, 04/11
6. STRIKE INSTALLATION
Z-BRACKET
(M38 Shown)
DRESS COVER
(M38 Shown)
9
5 (X2)
6
7
(REF. - EXISTING) STRIKE PLATE,
SEX BOLT, MOUNTING BUSHING,
ROLL PIN BUSHINGS & NEOPRENE
WASHERS (Provided with Original
Lock Installation Hardware)
13 (X2) *
(REF.)
(Door Hinge)
8
12 *
10 (X2) or
11 (X2)
Figure 5
*Note: Items #12 and #13 are not included with this kit. They are shown here for reference
when installing a “D” (Door Position) version lock using the TJ-bracket. See the Door Position
Actuator Installation section of this manual and the installation template furnished with the lock
for detailed mounting information.
After the mounting of the lock/TJ-bracket has been completed, use Figure 5 and the following
step-by-step installation sequence to complete the mounting of the Z-Bracket and strike
assembly to the door:
 After marking the Z-Bracket mounting holes on the door, center punch these locations.
 Drill one (1) 3/8” [9.5mm] diameter hole through door at the Z-Bracket center hole mark,
then drill 1/2” [12.7mm] diameter X 1-1/2” [38.1mm] deep through door from opposite side
for the sex bolt.
 From the side of the door that the Z-Bracket will be mounted, drill two (2) 7/32” [5.5mm]
diameter X 1-3/8” [34.9mm] deep holes at each of the other two marked locations.
 Position the bracket onto the door, aligning the bracket holes to the holes drilled in the door.
 Using a flat blade screwdriver (or hex drive socket/wrench), secure the bracket to the door
using the two (2) #14 X 1-1/4” long slotted hex head type “A” screws (Item #5) provided,
through the two holes on each side of the center hole.
 With the Z-Bracket partially installed and the door in the closed position, mark the bracket
horizontally and vertically to indicate the required center hole position for mounting the strike
plate.
 Using a screwdriver (or wrench), remove the Z-Bracket from the door and mark for the
remaining two (2) holes for the roll pin bushings - 2.25” [57.2mm] to each side of the center
hole (all holes share the same center line horizontally).