Securitron FMK-SL - Manual (Page 5)

PN# 500-22190
Page 5 Rev. D, 04/11
FIG 5
Installing the lock “L” Bracket and lock
Adjust the lock “L” bracket (#3) as shown in FIG 6, note: bracket #3 can be adjusted in any
manner necessary to locate the lock as needed for proper gate closure.
GL1 - Position the lock template onto Bracket #3, mark the four mounting holes for the GL1
and center wire feed hole if required. Carefully center punch and drill the four mounting holes
with a 13/64” bit and tap for 1/4-20 machine screws. Install the lock using the hardware as
shown in FIG 6A. Install GL1 chassis with indicated hardware in the upper holes. Complete
installation of the GL1 lock by referring to FIG 6A and following the installation guide
included with the GL1.
FIG 6A