Securitron EEB3N - Manual (Page 2)

PN# 500-12600
Page 2 Rev. E, 06/11
FIG 2: INTERNAL SCHEMATIC
C
NC
TRIGGER
C
NC
NO
PUSH
BUTTON
TIMER
TO LOCK "+" WIRE
GREEN
RED
+12V OR +24V
WHITE
TO +V
BLACK
0 V (DC NEG)
4. ALTERNATE LENS CHANGING
EEB2
1) Grasp keyplate and turn over. From the back rotate the white contact block of the switch counter-
clockwise to the 11 o’clock position and pull straight back to remove the contact block.
2) With a slender smooth ended object such as a marker pen, slide it inside the switch body. With the
object inserted in the switch up against the lens, place the object on a smooth surface with the
keyplate on top and tap the keyplate up and down on the object to pop the lens off. Remove the lens
and insert.
3) Turn the keyplate over and place the new insert onto front of switch, confirm that the text on the
insert is correct reading to the keyplate and place the matching colour lens on top on insert and
compress around all edges of the lens until it snaps in place. Depress lens several more times to
ensure smooth operation and that the lens is not binding.
4) With the terminals upward insert the contact block back into the back of the switch at the 11 o’clock
position and rotate clockwise until it stops straight up and down.
EEB3N
1) While holding keyplate grasp the top and bottom of the lens and pull straight out from the keyplate.
2) Place the new lens over the switch face, confirm that the text on the lens is right reading to the
keyplate and push down completely until it snaps into place. Depress lens several time to ensure
smooth operation and that the lens is not binding.
5. MAGNACARE  LIFETIME REPLACEMENT WARRANTY
For warranty information visit: www.securitron.com/en/site/securitron/About/MagnaCare-Warranty/
NOTE:
Positive input voltage
on the white wire must
be from same power
source that the red &
black wires are
connected to.