Securitron MK_Series - Manual (Page 3)

PN# 500-11700
Page 3 Rev. D, 11/11
FIG 2: MK PHYSICAL AND ELECTRICAL DETAILS
WHITE
RED
BLUE
SW
IT
C
H
WI
R
E
S
COM=
N.C.=
N.O.=
MORTISE
CYLINDER
BAT CAM
BRASS RING NUT SECURES CYLINDER
APPLY THREADLOCK (SUPPLIED)
TO THREADS
SECOND SWITCH WOULD MOUNT HERE
POSITION (UP OR DOWN) OF SWITCH IN MOUNTING HOLE IS SET TO CONFORM TO EXACT
CAM USED. FOR INSTANCE, THE SWITCH NORMALLY MOUNTS HIGHER TO WORK WITH A
BAT TYPE CAM (SHOWN) THAN WITH A CLOVERLEAF TYPE CAM. IN THE CASE OF SOME
CLOVERLEAF CAMS, THE SWITCH MAY BE MOUNTED IN THE CENTER POSITION AND THE
KEY WILL OPERATE THE SWITCH WHEN TURNED IN EITHER DIRECTION. YOU MUST
EXPERIMENT WITH THE SWITCH MOUNTING POSITION TO BE SURE OF CONSISTENT
FUNCTION. THEN LOCK THE SWITCH IN POSITION WITH THE LOCKING NUT HARDWARE.
KEY REMOVES WHEN CAM IS IN DOWN
POSITION
SWITCH
1 1/8" OR 1 1/4"
ANY CAM
GREEN LED WIRE
RED LED WIRE
BLACK LED WIRE (NOTE RESISTORS)
BOTH LED COLORS OPERATE ON 24 VOLTS
AS DELIVERED. REMOVE THE OUTER
RESISTOR TO OBTAIN 12 VOLT OPERATION.
BLACK WIRE IS DC COMMON NEGATIVE FOR LED.
NOTE: LED COLORS MUST ONLY BE ILLUMINATED ONE AT A TIME.
SEE SECTION 3 IN MANUAL (ABOVE) IF IT IS REQUIRED TO ILLUMINATE BOTH SIDES
OF THE LED AT THE SAME TIME
APPLYING +VDC TO GREEN LED WIRE ILLUMINATES GREEN.
APPLYING +VDC TO RED LED WIRE ILLUMINATES RED.
LED
4. MAGNACARE  LIFETIME REPLACEMENT WARRANTY
For warranty information visit: www.securitron.com/en/site/securitron/About/MagnaCare-Warranty/