Securitron SABL QUICK START GUIDE - Manual (Page 4)

PN# 500-19750
Page 4 Rev. B, 03/11
Below is a step by step summary of programming the two codes.
 Press the “PRGM” button on the CPU board for one second.
 Confirm rapid flashing yellow LED.
 Within 30 seconds of pressing PRGM button, enter prefix 0-0 followed immediately
by a 5-7 digit Program Code.
 Note two (2) red LED flashes for confirmation (may take up to 5 seconds), note
rapid yellow flashing LED returns.
 Enter prefix 0-1 followed immediately by a 2-7 digit User code. Prefixes are 01-55
 Note two (2) red LED flashes for confirmation (may take up to 5 seconds), note
rapid yellow flashing LED returns.
 Press “E” key to terminate program mode or wait 30 seconds.
 Re-enter User code (door should open).
 Re-enter Program Code followed by the “E” key (yellow LED should rapidly flash);
terminate with “E” key.
4.2.1. Changing The User and Program Code from the Keypad
This is the day to day procedure that should be taught to the end user. To change the
User code:
 Enter Program Code, followed by the “E” key, note rapid yellow flashing LED
(program mode).
 Enter prefix (01 thru 55) followed immediately by a new 2-7 digit User code.
 Note two red LED flashes for confirmation, note rapid yellow flashing LED returns.
 Press “E” key to terminate program mode or wait 30 seconds.
 Re-enter new User code (door should open).
The Program Code should need changing much less often. To do it:
 Enter old Program Code followed by the “E” key, note rapid yellow flashing LED
(program mode).
 Enter prefix 0-0 followed immediately by a 5-7 digit new Program Code.
 End your entry with “E” key or wait 5 seconds.
 Note two red LED flashes for confirmation, note rapid yellow flashing LED returns.
 Press “E” key to terminate program mode or wait 30 seconds.
 Re-enter new Program Code followed by the “E” key (to test it), note rapid yellow
flashing LED returns.
 Press “E” key to terminate program mode or wait 30 seconds.
5. COMMAND SUMMARY
WITH THE UNIT IN PROGRAM MODE (FAST YELLOW FLASH):
00 followed by 5-7 digits sets Program code.
01 followed by 2-7 digits set first User code.
02 followed by 2-7 digits sets second User code.
Additional User codes can be set up to the prefix 55 (total 59 User codes).
56-57 followed by 2-7 digits sets Passage Mode.
58-59 followed by 2-7 digits sets Lockout Mode.
71 will silence beeper at all times.
72 will return beeper to factory set.
73 will reverse light logic (red to echo, green to show door is open).
74 will return light logic to normal.
79 is alternate code delete. Any valid code entered directly after the 79 command will be
deleted.
88 will erase all user codes (not Program or Hard Code).
89 will return all functions (including timer) to factory set. Codes are unchanged.
Pressing 9 when in program mode sets the timer. Two digit codes must be entered from
01 to 09 seconds. Default is 3 seconds.