3setup, 1troubleshooting procedures – Securitron WSS User Manual
Page 3
4 Installation/Wiring/Setup (Continued)
5 Troubleshooting
3
Setup
Potentiometer
Output Mode Switch
24”
4”
Pulse Mode
Toggle Mode
4”
24”
WSS
Sensing Field
1. Adjust unit to desired setup. Two adjustments can
be made to the sensor. The Potentiometer is used
to adjust the size of the units’ sensing field and the
Output Mode switch is used to select Toggle or Pulse
mode.
2. Rotate potentiometer clockwise to increase the sensing
field. It may be adjusted from 4” to 24”.
3. Adjust Output Mode by moving switch in the up position
(Toggle Mode) or in the down position (Pulse Mode).
Toggle Mode: Recommended for switch applications. In
Toggle mode a detection activates the relay
and a second detection deactivates the
relay.
Pulse Mode: Recommended for automatic door
applications. In Pulse mode a detection
activates the relay for a short period of time
- depending on the duration of movement in
front of door.
1
Troubleshooting Procedures
PROBLEM
PROBABLE CAUSE
CORRECTIVE ACTION
Door does not open when swiping
hand in front of sensor.
1. Bad or no power supply.
2. Detection range is too small.
3. Wrong connection.
1. Check power supply. If LED
switches on or flashes, power
connections are OK.
2. Adjust the detection range.
Remove any metal plates in
front of sensor.
3. Check wiring and relay
connection.
Door remains permanently open.
1. Environmental conditions are
influencing the sensor.
2. Wrong connection.
1. Remove any moving objects
close to the sensor.
2. Check wiring and relay
connection.
The door remains open after
detection/activation
1. Wrong output mode.
2. Wrong connection
1. Switch the output mode to
Pulse mode.
2. Check wiring and relay
connection.
FCC APPROVAL
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection agianst harmful interference in a residential installation. This equipments generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does not cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
*Reorient or relocate the receiving antenna
*Increase the separation between the equipment and receiver
*Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
*Consult the dealer or an experienced radio/TV technician for help
WARNING: CHANGES OR MODIFICATIONS TO THIS EQUIPMENT NOT EXPRESSLY APPROVED BY BEA INC. MAY VOID THE FCC AUTHORIZATION TO OPERATE THIS EQUIPMENT.
Securitron Magnalock Corp
Tel 800.624.5625
www.securitron.com
500-23700_A