SilverStone ST50F-ESG - Manual (Page 3)

STRIDER ESSENTIAL SERIES
02
MINIMUM
LOAD
NORMAL
LOAD
MAXIMUM
LOAD
LOAD
REG
LINE
REG
RIPPLE & NOISE
+3.3V
+5V
+12V
-12V
+5Vsb
0.2A
1A
1A
0A
0A
10A
10A
24A
0.25A
1A
25A
25A
56A
0.3A
3A
±5%
±5%
±5%
±10%
±5%
±1%
±1%
±1%
±2%
±1%
50mV P-P
50mV P-P
120mV P-P
120mV P-P
50mV P-P
SST-ST50F-ESG:
8Amp (maximum) at 100-127Vrms/60 Hz
4Amp (maximum) at 200-240Vrms/50 Hz.
SST-ST70F-ESG:
+5Vsb peak current is 4A(less then 0.5S)
(1) +3.3V & +5V total output not exceed 160W.
When +5V is load to 25A, the +3.3V maximum load is 10.6A.
When +3.3V is load to 25A, the +5V maximum load is 15.5A.
(2) All outputs shall be safety-isolated from the AC mains and share a common return.
This common return must be connected to supply chassis.
(3) Voltages and ripple are measured at the load side of mating connectors with a 0.1uF
monolithic ceramic capacitor paralleled by a 10uF electrolytic capacitor across the
measuring terminals.
The AC mains steady-state input voltage shall be 100 to 240 Vrms
The power supply shall operate from 90 to 264 Vrms.
The power supply shall operate from an AC mains frequency of 47-63Hz.
The AC mains steady-state RMS input current shall be:
SST-ST70F-ESG:
10Amp (maximum) at 100-127Vrms/60 Hz
5Amp (maximum) at 200-240Vrms/50 Hz.
2.0 INPUT REQUIREMENTS
SST-ST60F-ESG:
8Amp (maximum) at 100-127Vrms/60 Hz
4Amp (maximum) at 200-240Vrms/50 Hz.
3.0 OUTPUT REQUIREMENTS
3.1 OUTPUT VOLTAGE AND CURRENT