SilverStone ST50F-ESG - Manual (Page 6)

05
X
X
1.5A
24A
1.5A
3A
3.6A
10A
13.25A
12A
LOAD CONDITION NO
OUTPUT LOAD
+3.3V +5V +12V -12V +5Vsb
COND.1 1
COND.2 2
COND.3 3
COND.4 4
COND.5 5
COND.6 6
COND.7 7
COND.8
COND.9
COND.10
8
9
10
X
X
1A
1A
20A
6A
3.6A
9A
11.04A
12A
X
X
1A
7A
7A
39A
2.6A
20A
36A
32.15A
X
X
0A
0A
0A
0A
0.3A
0.25A
0.26A
0.3A
3.5A
3A
0.1A
0.1A
0.1A
0.1A
3A
1A
2.47A
3A
LOAD REGULATION CHARACTERISTICS
Cond. 10 only at 115Vac/60Hz and less then 1 S
Cond. 1 only at 115Vac/60Hz and less then 100 mS
(1) +3.3V & +5V total output not exceed 120W.
When +5V is load to 20A, the +3.3V maximum load is 7.5A.
When +3.3V is load to 24A, the +5V maximum load is 9A..
(2) All outputs shall be safety-isolated from the AC mains and share a common
return. This common return must be connected to supply chassis.
(3) Voltages and ripple are measured at the load side of mating connectors
with a 0.1uF monolithic ceramic capacitor paralleled by a 10uF electrolytic
capacitor across the measuring terminals.
3.2 REMOTE ON/OFF CONTROL
The power supply shall accept a logic open collector level which will disable/ enable all
the output voltage (exclude + 5V standby).
As logic level is low, outputs voltage were enabled.
As logic level is high, outputs voltage were disabled.
Note: 1. Logic high level: 2.0-5.25V while sourcing 0.2mA maximum.
2. Logic low level: 0-0.5V while sinking 1.6mA maximum.
3. Rise Time: 15ms maximum (10%-90%).