SKC 225-380 Parallel Particle Impactor - Manual (Page 8)

8
Ordering Information
PPI Samplers, require fi lter, substrates, and support Cat. No.
Respirable PPI (gold), 2 L/min 225-380
Thoracic PPI (blue), 2 L/min 225-381
Respirable PPI (red), 8 L/min 225-383
Recommended Collection Filters for PPI, required for sampling
Select a fi lter based on your application.
PVC Filters, 37 mm, 5.0-μm pore size, pk/100
225-5-37
PTFE Filters,* § 37 mm, 2.0-μm pore size, with laminated PTFE support,
for metalworking fl uids (NIOSH 5524), pk/50 225-27-07
MCE Filters, 37 mm, 0.8-μm pore size, pk/100 225-5
Filter Supports, required for sampling. Select either cellulose or stainless steel.
Support Pads, cellulose, 37 mm, pk/100
225-27
Support Screen, stainless steel, 37 mm, wide mesh, ea 225-26
Impaction Substrates, four required for each sample
Porous Plastic Discs,
3 /
8
-inch diameter, pre-oiled, ready-to-use,
disposable, pk/200
Limited shelf-life
225-388
Accessories
Multi-purpose Calibration Jar
225-111
Forceps, stainless steel, with non-serrated fl at tips 225-8371
Filter-Keeper ™ , for transporting and storing 37-mm fi lter samples, pk/10 225-8303A
* Back pressure on PTFE fi lters can vary within the same lot.
§ If using PTFE Filter Cat. No. 225-27-07 as specifi ed in NIOSH 5524 for Metalworking Fluids, follow the procedure
in NIOSH Draft Appendix for NIOSH 5524 at www.skcinc.com/instructions/38030.pdf to mitigate problems with
weight instability and subsequent high blanks following extraction. Failure to follow the procedure in the NIOSH
Draft Appendix will result in invalid samples.
For Disposable PPI Samplers,
visit www.skcinc.com/prod/225-3841.asp.
SKC Limited Warranty and Return Policy
SKC products are subject to the SKC Limited Warranty and Return Policy, which
provides SKC’s sole liability and the buyer’s exclusive remedy. To view the com-
plete SKC Limited Warranty and Return Policy, go to htt p://www.skcinc.com/
warranty.asp.
Form 38038 Rev 1402
www.skcinc.com