Sonnet Technologies 6Gb_s SAS_SATA RAID Controller Card - Manual (Page 4)

4
Windows Server 2003/Windows XP Driver and
Software Installation
This section describes the installation of drivers to support the
Sonnet RAID controller in systems running Windows Server
2003 or Windows XP.
1. Start Windows and log on as System Administrator.
2. Insert the included software CD; an Internet Explorer
window will appear.
3. If a window appears warning about active content, check or
uncheck the checkbox per your needs, and then click Yes.
4. Click the Windows Drivers link in the upper left corner.
5. Click the link for the drivers that apply to your computer.
6. If you are using a 32-bit version of Windows XP, click the
Install SCSIport Driver link under the Windows XP heading.
If you are using a 64-bit version of Windows XP, or any
version of Windows Server 2003, click the Install Storport
Driver link under the appropriate heading.
7. When the File Download - Security Warning window appears,
click Run.
8. When the Internet Explorer - Security Warning window
appears, check or uncheck the checkbox per your needs, and
then click Run.
9. When the ATTO Windows Driver Installer window appears,
click Install.
10. When the Setup window appears, click OK.
11. After the driver installation is complete, a window will
appear with a message stating no adapter was detected; click
No to close the window and continue with the software
installation.
12. Back in the browser window click the Windows Applications
link on the left.
13. Click the Install Configuration Tool link.
14. When the File Download - Security Warning window appears,
click Run.
15. When the Internet Explorer - Security Warning window
appears, click Run and the installer will launch.
16. When the Introduction window appears, click Next.
17. When the License Agreement window appears, click the radio
button next to the option to accept the license agreement,
and then click Next.
18. When the Choose Install Folder window appears, either
accept the default location or choose a new one, and then
click Next.
19. When the Choose Install Set window appears, click the Full
Installation icon, and then click Next.
20. When the Choose Java Virtual Machine window appears, click
the radio button next to the Choose a Java VM specifically
for this application option, and then click Next.
21. When the Pre-Installation Summary window appears, click
Install.
22. When the Install Complete window appears, click Done.
23. Back in the browser window, click the Install Windows
Utilities link.
24. When the File Download - Security Warning window appears,
click Run.
25. When the Internet Explorer - Security Warning window
appears, click Run.
26. When the Welcome to the ATTO HBA Utilities Setup Wizard
window appears, click Next.
27. When the Select Installation Folder window appears, either
accept the default location or choose a new one, and then
click Next.
28. When the Confirm Installation window appears, click Next.
29. After the utilities have been installed, an Installation Complete
window appears; click Close to exit.
30. Shut down your computer, and proceed to Hardware
Installation on page 6.
Software Installation Steps