Sonnet Technologies Encore_ST G4 (1.4 GHz and Slower) Processor Ugrade Card - Manual (Page 15)

13
Figure 39
Installation—QuickSilver 2001 and 2002 Models
Reinstall Fan Assembly and Close Computer
1. Place the fan assembly between the Encore/ST card’s heat sink
and the back panel of the computer, against the modem filter
(Figure 38). Carefully plug in the fan’s 2-pin connector to the
connector on the logic board.
2. With the back of the computer facing you, secure the fan assem-
bly to the back plate of the computer with the two screws you
removed previously
(Figure 39).
3. Raise the side panel back into place (Figure 40).
4. Return the computer to your computing area if necessary, and
reconnect the power cord and peripheral cables to the computer.
Turn On Computer
Turn on your Power Mac; your accelerated machine should boot
normally. Your installation is now complete.
screw screw
Figure 38
fan
2-pin
connector
Figure 40
side panel
modem
filter
Qu
ic
kS
ilv
er
2
00
1/
20
02