Sonnet Technologies Encore_ZIF 1.0 GHz Processor Upgrade - Manual (Page 7)


Install Power Adapter Cable Between Computer and
Encore/ZIF Card
1. Locate the logic board power cable plugged in next to the
Encore/ZIF card (Figure 13). Unplug the connector by pulling it
straight up while squeezing its locking tab.
2. Plug in the provided power adapter cable between the connector
on the logic board and the logic board power cable (Figure 14);
verify that all the connectors are plugged in securely.
Close Computer
1. Arrange the wires and cables inside the computer so that noth-
ing which may block airflow through the cooling fans runs
across the top of the Encore/ZIF card, and so that nothing will be
pinched when you close the internal assembly
(Figure 15).
2. Disengage the support arm from the bottom of the computer’s
case (Figure 16).
Hardware Installation—G3 Desktop
Figure 13
Figure 14
Figure 15
WARNING: When disconnecting cables from the logic board,
do not pull on the wires; always pull on the connectors.
Encore/ZIF card
power adapter
cable connector
logic board
connector
Encore/ZIF card
logic board power
cable connector
power adapter
cable connector
logic board power
cable connector
G3
D
es
kt
op
Figure 16
support arm