Grant Part #64036 - Revolution - Manual

CHRYSLER AIRBAG STEERING WHEEL REPLACEMENT PROCEDURES
Congratulations on the purchase of your new GRANT REVOLUTION steering wheel. This wheel is a
direct replacement for your original factory steering wheel with or without spoke mounted control
switches. The original airbag (SIR) module, wiring harness, trim/switches and rear shroud from the
factory wheel must be removed and transferred to the new GRANT wheel.
This wheel will fit the following vehicles:
Dodge Full Size Ram Pickups 2004-2008
Dodge Durango and Dakota 2004-2010
IMPORTANT - PLEASE READ
These GRANT Instructions use the factory shop manual procedures for the removal and
reinstallation of the steering wheel and airbag module. In addition the GRANT instructions
include step-by- step procedures for the changeover of the switches, wiring and trim pieces from
the factory wheel to the Grant wheel. Before proceeding with the replacement of your original
steering wheel, it is necessary to read and understand all these instructions. By reading them
first, you can become familiar with the steps and terminology used. Please take note of the
following directives used throughout these instructions:
ALWAYS CAUTION NEVER NOTICE NOTE
NOTICE - GRANT recommends that installation be performed by a qualified service provider such
as your local Mopar dealer, a certified mechanic, collision repair shop or a local airbag service
center. Many of these service centers will come to your home or place of business to change out
the air bag and wheel for a nominal fee. To find these providers check the internet for “airbag
service”, “mobile airbag service” or check the yellow pages.
CAUTION
ALWAYS WEAR SAFETY GLASSES WHEN REPAIRING OR HANDLING AN AIR BAG.
ALWAYS CARRY A LIVE AIR BAG MODULE WITH THE TRIM COVER POINTED AWAY FROM YOUR
BODY.
ALWAYS PLACE A LIVE AIR BAG MODULE ON A BENCH OR OTHER SURFACE WITH THE TRIM
COVER FACING UP.
NEVER PROBE THE CONNECTORS ON THE AIR BAG MODULE.
AIR BAG MODULES WITH DISCOLORED OR DAMAGED COVERS OR DEPLOYMENT DOORS
MUST BE REPLACED, NOT REPAINTED.
Tools required: Socket Set Safety Glasses
Torque Wrench 10mm Allen Wrench
Phillips Screw Driver
Form 97571-00-01
MODEL NUMBER