Harwin C90 Braid Adaptors - Spring Band - Manual (Page 2)

f) Bring the cable shield braid up onto the adaptor body so that it fits against the front
shoulder of the lip groove. Alternatively extend the braid past the lip groove.
Note: After assembly, braid can be trimmed with side cutters or folded back and secured
with high temperature tape.
Secure Cable Braid
End with Tape
Fold Cable Braid Back
g) Open up the constant force spring and wrap it around the cable braid section that is
positioned over the constant force spring slot area of the adaptor. This is most easily
accomplished by lifting up the end of the spring and trapping the braid covered adaptor
between the spring coil and raised end. The spring will now stay in place and can be
installed by simply rolling the spring coil around the braid covered adaptor.
h) Install heat shrink connector boot over braid and back of Adaptor, use industry standard
best practices.
Lift Up End of spring Trap braid-covered Adaptor between
Spring Coil and raised end
Roll Spring Coil around Adaptor
Harwin North America Harwin Europe Harwin Asia
T: +1 603 893 5376 F: +1 603 893 5396 T: +44 (0) 23 9231 4545 F: +44 (0) 23 9231 4590 T: +65 6 779 4909 F: +65 6 779 3868
E: [email protected] W: www.harwin.com E: [email protected] W: www.harwin.com E: [email protected] W: www.harwin.com.sg
IS-31 Issue: 1 Date: 01.06.10 C/Note: ---- Page 2 of 2