Heco Music Colors 200 - Manual (Page 7)

GB
7
GB
Otherwise please adhere to the general recommendations outlined in the previous chapters.
MAINTENANCE
The lacquered surface is best cleaned with a mild household cleaner. On no account use furniture polish
or similar products on these surfaces. You should not use a microfibre cloth either as this may damage
the surface.
HOW TO AVOID DAMAGE TO YOUR VALUABLE SPEAKERS
All HECO loudspeakers are designed and built for optimum sound reproduction with the tone controls
in the central position – i.e. with “linear” amplifier output. Turning up the bass and treble controls too far
delivers more power to the woofers and/or tweeters, and at high volumes this can actually destroy the
speaker units!
If the output of your amplifier is significantly higher than the rated power handling capacity of your
speakers extremely high volumes can physically destroy your speakers. This doesn’t actually happen
often but you should be aware that it is possible.
Weak amplifiers with low output ratings can actually be more dangerous for your speakers at medium
volumes because weak amplifiers may overload much faster than powerful ones and this causes
measurable and audible distortion, which is extremely dangerous to your loudspeakers.
Always turn the volume down immediately as soon as you hear distortion! If you like listening to loud music
make sure that your amplifier can deliver at least as much power as the speakers’ power-handling rating.
THE SOUND YOU CAN’T HEAR...
Amplifiers, tuners and CD players can all produce inaudible high-frequency signals – and this doesn’t
only apply to cheap products. If your tweeters fail at low or medium volumes you should have a qualified
technician check your system components for dangerous inaudible signals.
SPECIFICATIONS
Music Colors 200 Music Colors 100 Music Colors Center 80
Configuration: 3-way bass reflex 2-way bass reflex 2-way
Power-handling capacity: 140 / 220 W 70 / 120 W 60 / 120 W
Impedance: 4 – 8 ohms 4 – 8 ohms 4 – 8 ohms
Frequency response: 30 – 35 000 Hz 38 – 35 000 Hz 60 – 32 000 Hz
Recommended amplifier
output: 20 – 220 W 20 – 120 W 20 – 120 W
Efficiency (1W/1m): 90 dB 89 dB 88 dB
Dimensions (WxHxD): 150 x 1025 x 306 mm 150 x 235 x 200 mm 286 x 115 x 128 mm
Base plate dimensions: 220 x 320 mm
Accessory: Metal spikes
SUBJECT TO TECHNICAL CHANGE