Entering and exiting the command modes, Entering and exiting the command modes -2 – Avaya P580 User Manual
Page 20
Chapter 1
1-2
Command Reference Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
Entering and Exiting the Command Modes
See
for an explanation of how to access and exit the command
modes.
Table 1-2. Entering and Exiting the Command Modes
Router Configuration
Commands to configure the
routing protocols.
From Global mode, enter
router <protocol>
(dvmrp, igmp, ospf, rip,
or vrrp).
For DVMRP, OSPF,
and RIP: (configure
router:<protocol>)#
For IGMP and VRRP:
(configure)#
Interface Configuration
Commands to configure the
interfaces.
From Global mode, enter
interface <interface-
name>.
(config-if: <interface-
name>)#
Mode
Description
To Access
Prompt
2 of 2
Mode
To Access
Prompt Displayed
To Exit
User
Log in.
>
Enter exit.
Privileged
From the User mode,
enter enable.
#
Disable or exit returns to the
User mode.
Global
Configuration
From the Privileged
mode, enter configure.
(configure)#
Exit returns to the Privileged
mode.
Router
Configuration
From Global mode, enter
router <protocol>
(dvmrp, igmp, ospf, rip,
or vrrp).
For DVMRP, OSPF, and
RIP:
(configure
router:<protocol>)#
For IGMP and VRRP:
(configure)#
Exit returns to the Global
Configuration mode.
End returns to the Privileged
mode.
Interface
Configuration
From Global mode, enter
interface <interface-
name>
(configure-
if:<interface-
name>)#
Exit returns to the Global
Configuration mode.
End returns to Privileged
mode.