Terminal emulation with the intellitrack rf server, Configuring lxe® with intellitrack rf, Terminal emulation with the intellitrack rf – IntelliTrack Check In/Out User Manual
Page 21: Server 11, Configuring lxe® with intellitrack rf 11
Chapter 2
Device Setup
11
Important: If you cannot ping the portable, the Check In-Out RF Server
application will not run on the portable device. See your network adminis-
trator for help in setting up RF connectivity with the portable device.
Terminal Emulation with the IntelliTrack RF
Server
IntelliTrack RF supports RF Terminal Setup. In conjunction with the RF
Server, terminal emulation allows your IntelliTrack RF application to con-
nect to a portable Windows® CE and CE.NET device. Prior to transferring
data between the desktop computer and a portable CE or CE.NET device,
it is essential to establish the correct CE or CE.NET device portable set-
tings. For supported models, please visit the hardware matrix on the Intelli-
Track Website, which can be reached by following this web address:
Configuring LXE® with IntelliTrack RF
The IntelliTrack RF application may be used with a LXE® MX3-CE
device by using the LXE RFTerm application with the LXE device. In
order for it to work together properly, you must configure the LXE
RFTerm application as outlined in the steps below.
1.
Install the RFTerm.cab file on the LXE MX3-CE terminal.
Note: If it is already installed, make sure you have version RFTRM-
PCE.1Hd or higher and the build is 20040621.1Hd or higher.
2.
Open the RFTerm application on the LXE device desktop by double-
clicking on the LXE RF Term icon or clicking Start > Programs >
LXE RF Term from the Start menu.
3.
Next, select Session > Configure from the menu to open the Configure
screen.