Inter-M ARM-911 - Manual (Page 10)

AUTOMATED REMOTE MESSAGE
7 ARM-911
Operation Method Operation Method
1. SD Disk Function
2GB SD memory is installed both front SD card and internal Backup SD card.
(1) Take out the SD memory from the unit.
Screw off the cover. Push and release the center of the SD
memory and then take out the SD memory.
The window displays ‘No Device’.
(2) Storing message files
① Save 10 message files into the SD memory.
② The track number of the SD disc is in numerical order.
The track number is directly corresponded to the front 10 buttons. So, name the message files as below.
01.mp3, 02.mp3, ......, 09.mp3 and 10.mp3.
(3) Plug the SD memory into the slot
Be sure the direction when insert a SD memory into the slot.
Follow the direction silk under the slot.
Plug the SD memory into the slot until it is locked.
Screw the cover on the slot.
(4) The window displays ‘READY’.
(5) Press the Instant Play Button from 1 to 10 respectively to check the message file stored in the SD memory.
When press the Instant Play Button, then the indicating LED is lit.
If the files stored in the SD memory is less than 10 files, then the correspond indicating LED is not lit even if
the button is pressed.
(6) Press the button again to stop playback.
2. SD Disk Copy Function
Use this function to make a backup for the SD memory.
(1) Press the COPY button on the front. The window displays ‘PRESS THE MODE KEY ONCE MORE’. Press the
DISPLAY MODE to start copy. If the Display Mode button is not pressed within about 3 seconds, then the
COPY function is cancelled.
The unit reads the files from the front SD memory and then copy to the Internal backup SD memory.
The window displays ‘COPYING’.
When the copy is finished, the window displays ‘READY’.
(2) Take out the SD memory from the front slot.
(3) Press the Instant Play Button from 1 to 10 respectively to check the message files copied from the front SD
memory.