Inter-M PX-8000 - Manual (Page 8)

8X8 AUDIO MATRIX SYSTEM
6 PX-8000
8. PAGING ALL BUTTON
If broadcasting a Paging MIC to all output areas, firstly pressing this button before pressing the TALK button
enables to select all the output areas. Buttons of all the Paging broadcasting areas turn on. If pressing the
buttons again, the relevant function is released. (Applied even to system link)
9. REC BUTTON
Enters into the Recording Standby Mode if pressing the REC button. Check that alphabet
character called as "-record-" is displayed. (Recording mode is released if pressing the ESC button in the
Recording Standby Mode. Press the REC button to release during recording.)
If recording standby is completed, start recording by pressing this button lengthily (about a second). Check
that recording is being done while the first character and ending character "-" from the "-RECORD-" rotate.
If recording is completed, end by pressing the REC button. (Maximum recording time is 30sec.)
10. TREBLE/BASS/LEVEL ADJUSTMENT VOLUME
Adjusts volume and tone when broadcasting MIC and when recording built-in DRP IC.
11. BGM INPUT LED
A LED of the input channel, where BGM signal comes from, turns on.
12. POWER SWITCH
A switch to apply power supply to the system
13. MONITOR SPEAKER VOLUME
A volume to adjust BGM volume output to the Monitor Speaker
14. MASTER/SLAVE LED
Displays mode in link of PX-8000. This turns on depending on the status of the rear Link Mode switch.
15. WALL MOUNT CONTROLLER (LM-8000) ENABLE BUTTON
This is a toggle switch to select whether the WALL Controller (LM-8000) connected to each output zone is
enable/disable. If the button turns on, selection of BGM and adjustment of BGM output volume are done only
by LM-8000. If the button turns off, the related right is transferred to PX-8000. In this case, volume of the
output area is returned to the original status. Even for PX-8000 powering ON/OFF, the right is automatically
memorized.
16. PAGING ZONE SELECTION BUTTON
Button to select the desired output area when broadcasting using a paging MIC.
Has a toggle function and the selected button turns on.
17. PAGING MIC
An input jack to connect a Paging MIC. It is recommended to use a balanced MIC.
18. BGM LIST
A position to write name for user to easily discern each BGM input source.