ION Audio Live LP - Manual (Page 4)

4
Features
1. Platter – Place your record here.
2. Tonearm* – The tonearm can be raised and
lowered by hand, or by pressing the raise /
lower lever. Please note that the tonearm
needs to be moved away from resting position
(on the arm clip) for the turntable motor to
activate. When the tonearm is placed back in
its resting position, the turntable motor will
deactivate if Autostop has been turned on.
3. Arm Clip – This specially designed arm clip
secures the tonearm while at rest or when not
in use. The arm clip has been designed to
remain in the up position while unlocked.
4. Raise / Lower Lever – Raises and lowers the
tonearm.
5. 33 / 45 / 78 Switch – This switch controls the
RPM of the turntable platter.
6. 45 RPM Adapter Holder – Holds the
included 45 RPM adapter. When not using
the adapter, please place it in this holder.
7. Autostop Switch – This switch turns
autostop on or off. When autostop is on, the
platter will start spinning when the tonearm is
placed over the record and stop spinning when the
record has reached the end. (When autostop is off, the
platter will always spin regardless of the position of the
tonearm.)
Note: If your vinyl record stops before it reaches the
end of the music, turn Autostop to the off position for
this particular record. This is generally recommended
for 45 RPM records.
8. Speakers – Listen to the audio from your playing vinyl
record.
9. Volume – Controls the audio output from your
speakers.
10. RCA Output** – The audio from a playing vinyl record
is sent to this line-level coaxial audio output. This must
not be connected to phono level devices. (If you do not
already have an RCA cable, this can be found at a
local electronics retailer.)
11. Power – Use the included adapter to connect to wall power.
12. Power Button – Press this button to turn Live LP on/off.
IMPORTANT: Remove the plastic
cartridge cover (needle cover) before
operating the turntable.
** WARNING: The RCA outputs are LINE
level. Please only connect these to LINE
level inputs. You may damage your
receiver if you plug in a LINE level device
into a PHONO level input.
AUT O ST
OP
ON OFF
1 2
4
3
5
7
8
8
9
6
11 12
10
* IMPORTANT: If the turntable's stylus
becomes worn, purchase a replacement
at ionaudio.com/ict09rs. If you play 78
RPM records, we recommend using a 78
RPM stylus, which you can purchase at
ionaudio.com/ict06rs.