IPA Tools 9001 Pulsar Master Kit - Manual (Page 7)

6
TOOL MAINTENANCE & STORAGE
The PULSAR ™ should be stored in a cool dry area. The operating
temperature is between 32 ° - 95° Fahrenheit and storage is 0° – 125°
Fahrenheit. Keep moisture away from tool at all times.
DOs & DON’Ts
DO clean tool and display with a scratch free damp cloth (completely
squeeze out excess water or mild soap).
DO store tool in its soft case when not in use.
DO NOT leave on the dash board in the hot sun or any area subjected to
excessive heat.
DO NOT store in direct sunlight.
DO NOT clean tool with caustic shop cleaners i.e. carburetor cleaner,
de-greaser, acetone, gasoline, etc.
DO NOT push on display screen with excessive force or it may break.
DO NOT let the tool come in contact with battery acid.
DO NOT drop the tool.
READING THE DISPLAY
The PULSAR ™ contains two sets of LED display numbers; UPPER and
LOWER. The UPPER set of LED
’s contains four digits. The main
function of these digits is to read
“Actual Current” from the circuit being
tested.
Additional functions of the UPPER display indicate: Voltage, Peak Hold,
Mute status and Pulse notification. The LOWER LED Display
’s main function
is to show the Amperage limit set by the user. Additional functions of the
LOWER display include
“Lock Status” indicated by a “decimal” in the bottom
right hand corner of the display. The lower digits also blink when the
PULSAR
™ has been engaged into
“INRUSH MODE”.
DIAGRAM OF DISPLAY (Fig. 2)