IPA Tools 9008-DL Super MUTT Deluxe Edition - Manual (Page 24)

24
AXLE AND WHEEL INSTALLATION
• Insert axle (fig. 8-A) into left and right axle bores fig. 8-B) at rear underside
of the MUTT ® .
• Slide 1 spacer (fig. 8-C) onto each side of the axle (fig. 8-A).
• Install 1 wheel (fig. 8-D) onto each side of the axle (fig. 8-A) with valve stem
facing away from the MUTT ® .
• Insert 1 E-Clip (fig. 8/9-E) into the groove (fig. 9-F) in the axle end in front of
the wheel to each side.
• Check tire pressure. It must not exceed 8PSI.
Fig. 8 - Axle and Wheel
Installation
NOTE: Install the Foot at the bottom of the unit with 45° angle side towards
the back of the unit
Fig. 9 - E-Clip Installation