For your safety, Specification – Jackco Model 66200B User Manual

Page 2

Advertising
background image

FOR YOUR SAFETY

• The vehicle to be lifted should never exceed the rated capacity of the jack.

• The jack should be supported on a solid and level surface, which is well illuminated and free of

obstructions. Never use the jack in a surface at which it may sink into the ground.

• Ensure that there are no persons inside the vehicle to be lifted. Switch off the engine and apply the brake.

Ensure the vehicle to be lifted against any type of sliding.

• Do not enter the vehicle or start the engine while it is supported on the jack or appropriate stands. The

jack is a lifting device only and should never be used to move the vehicle.

• Position the jack under the manufacturer’s recommended lifting point for the vehicle and ensure that it

is not corroded, dirty or greasy. This point should remain centered over the jack saddle. All off-centered

loads can slip and accidents may result.

• During raising and lowering of the load, all precautions should be taken to avoid movement of the vehicle

load. Traffic may cause the raised vehicle to rock during roadside use of the jack.

• The jack should be positioned so as to avoid the need of the user to introduce any part of his/her

body underneath the vehicle. Never work under a raised vehicle without previously supporting it with

mechanical/jack stands.

• Never position any part of your body near the movable parts of the jack.

• It is necessary for the operator to be able to observe the lifting process and the load’s movements. In

the presence of dangerous conditions, such as movement of the vehicle etc, the lifting process must be

interrupted.

• Ensure that there are no persons or obstructions underneath the vehicle prior to lowering.

• As an additional safety measure against overload, if the jack will not lift a load that is higher than the rated

capacity. A bypass valve set at the factory and which should not be adjusted under any circumstances.

Use wheel chocks appropriately.

SPECIFICATION

Capacity:

2 ton

Saddle Diameter :

4 in

Min Height :

2-3/4 in

Strokes to Max Height:

8

Max Height :

24 in

Net Weight :

94.25 lbs

Dimension:

32-1/2 in (L) x 14-1/2 in (W)

2

Advertising