JuiceGoose RC DM3 - Remote Control Combiner - Manual (Page 3)

lets. If desired, signal cable can be purchased directly from Juice Goose at
specified lengths for a nominal charge.
To assemble CQ signal cable: using the proper tools, cut the cable to the
desired length making sure the ends are cut straight, not diagonally. Strip
the outer insulation from the cable exposing approximately 1/4” of the
colored wire strands inside the cable. Be careful not to remove or break
the colored insulation on the inner conductors.
The exposed wires should then be inserted into the connector so that each
of the eight separate wires fits into an individual terminal position in the
connector, is flush with the tip of the plug and touches the gold connector.
NOTE: Orientation of the cable wire colors is reversed from one con-
nector to the other. When the connectors are viewed side to side with
the connector clips up, the wire colors should mirror one another. It is
best to insert the cable into the first connector so that the black wire is
on the left. The second connector should be attached so the black wire
is on the right when viewed from the same perspective as the first.
The connector should be crimped to hold the cable firmly to the connector.
Once the cable has been attached to the modular connectors, the cable may
join the CQ Series units or RC remote accessories.
REMOTE SWITCH CONNECTION
The input on the RC-DM3 can also be connected to a latching contact clo-
sure such as a switch or relay. The following instructions are provided to
assist with this configuration. This information is also useful for assem-
bling interface wiring going to and from the RJ type cable specified for the
CQ system.
1 2 3 4 5 6 7 8
8 7 6 5 4 3 2 1
INPUT
OUTPUT