JuiceGoose RC DM3 - Remote Control Combiner User Manual
Page 5
IN CASE OF MALFUNCTION
The Juice Goose RC-DM3 is ruggedly constructed and contains high
quality components to give years of performance. Should there be a prob-
lem, the following checklist is provided as a diagnostic aid.
SYMPTOMS AND SOLUTIONS
1. One or more CQ units attached to the RC-DM3 will not operate prop-
erly.
a. Is the CQ signal cable properly attached between the CQ
units? If an RC-5 is being used , check the “System
OK” indicator when the key switch is in the “Pause”
position.
b. Check the breaker on the specific CQ unit in question.
c. Refer to the CQ Series Owners Manual.
2. If a Sequence Up or Sequence Down is interrupted while in process by
a general power failure, reset the RC5 or CQ device that initiated the
sequence command to begin the sequence process again.
3 In the event of a brief (less than approximately 1.5 seconds) interrup-
tion of power to the RC-DM3, the operational signal output of the unit
will be maintained in the state existing prior to the interruption. After
interruption of greater duration, the RC-DM3 will automatically revert to
a “Pause” signal output, neither sequencing up nor down the CQ system.
If a longer term power interruption has affected the RC-DM3 and the
connected CQ units the system will require reactivation via the RC5 ter-
minals or other switch device.
If the problem cannot be remedied, if the encountered problem does not
appear on this list, or particularly if any evidence of severe malfunction is
observed, disconnect the RC-DM3 from your system and contact your
dealer/contractor or Juice Goose.
REPAIR
Should your RC-DM3 require repair, contact Juice Goose for assistance
and a Return Authorization (“RA”) Number. Please note that no returns
will be accepted without this authorization number.
CONTACT JUICE GOOSE AT
7320 Ashcroft, Suite 104
Houston, Texas 77081
P: 713-772-1404
F: 713-772-7360
www.juicegoose.com