Atlas Sound Sound Masking Generator/ Equalizer ASP-MG24 - Manual (Page 7)

OWNER'S MANUAL
Specifications are subject to change without notice
www.AtlasSound.com
1601 JACK MCKAY BOULEVARD ENNIS, TEXAS 75119 U.S.A. • TELEPHONE: (800) 876-3333 • FAX: (800) 765-3435
© 2007 ATLAS SOUND LP Printed in U.S.A. ATS002766 RevA 4/07 7
ASP-MG24
5.0 GETTING TO KNOW THE SOFTWARE
5.1. Loading the software
1. Load the software onto your computer by following the Quick Star Guide and Software Installation
Guide.
2. Note: It is important to have your computer screen resolution set to the highest viewing
setting or a minimal setting of 1280 x 1240 pixels. Failure to do may cause the dialog boxes to
appear out the viewing area. To find a window that should appear use the master screen curser
Up/Down arrows to find the three boxes. All screens can be moved by clicking and holding the
selected screen for personal viewing preferences.
3. After the software is loaded and the proper screen resolution is set. Open the software and follow
the steps below: Note: It is not necessary to have the computer connected to the ASP-MG24
viewing and program purposes.
5.2. Opening the Software
1. Your screen should look like the view below. If not, close the software and restart.
2. If you have the ASP-MG24 connected to your computer click “Yes “ to connect or you can work in
Off Line Mode by clicking “NO”.
3. After you have the screen above, click on (1) Start, (2) Log On and then (3) Enter. Do not put
anything into the pass word box at this time. Later you will assign one if needed. If a pass word
has been assigned, you will need to enter it.