Restore factory default, Upgrade device firmware – LevelOne FCS-0071 User Manual
Page 50
FCS-0071 User’s Manual
49
49
FAQ
Restore Factory Default
In some cases, system does not respond to any operation, this process gets the unit back to initial status,
so that it can be reconfigurable for up and running again.
To restore factory default, please follow the steps:
1.
Unplug the power jack to turn off the camera
2.
Insert a pin into the reset hole pressed the reset button and keep it pressed until instructed to
release.
3.
Plug in the power jack to turn on the camera. The power LED will start flashing in a short
while.
4.
Release the pin when the LED starts quick flashing. The device should be set back to factory
default.
Upgrade Device Firmware
Firmware upgrade process should be done via the web configuration; Setup -> Server Maintenance ->
Firmware Upgrade. Before the process, read the instructions and release notes coming with each new
released version.
1. Check and retrieve the latest firmware bin file.
2. Disconnect all clients (e.g. streaming requests) to the device that will be firmware
upgrading.
3. Stop the local (schedule) recording if it was enabled.
4. Go to the Firmware Upgrade page, browse and locate the downloaded firmware bin file,