Chapter 4 . troubleshooting, Chapter 4, Troubleshooting – LevelOne WBR-6804 User Manual
Page 61
61
Chapter 4 . Troubleshooting
This Chapter provides solutions to problems for the installation and operation of the WiFi Combo
Router. You can refer to the following if you are having problems.
1 Why can’t I configure the router even the cable is
plugged and the LED is lit?
Do a Ping test to make sure that the WiFi Combo
Note:
It is recommended that you use
Router is responding.
an Ethernet connection to configure it.
Go to Start > Run.
1.
Type cmd.
2.
Press OK.
3.
Type ipconfig to get the IP of default gateway.
4.
Type “ping 192.168.1.1”. Assure that you ping the correct IP Address assigned to
the WiFi Combo Router. It will show four replies if you ping correctly.
Ensure that your Ethernet Adapter is working, and that all network drivers are installed
properly. Network adapter names will vary depending on your specific adapter. The
installation steps listed below are applicable for all network adapters.
1.
Go to Start > Right click on “My Computer” > Properties.
2.
Select the Hardware Tab.
3.
Click Device Manager.
4.
Double-click on “Network Adapters”.