LevelOne IFE-0502 - Manual (Page 14)

Mounting Installation
DIN-Rail Mounting
The DIN-Rail is screwed on the industrial switch when out of factory. If the DIN-Rail is
not screwed on the industrial switch, please see the following pictures to screw the
DIN-Rail on the switch. Follow the steps below to hang the industrial switch.
1. Use the screws to screw the DIN-Rail on the rear side of the industrial switch.
2. To remove the DIN-Rail, reverse the step 1.
3. After the DIN-Rail is screwed on the rear side of the switch, insert the top of
DIN-Rail into the track.
14